Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
Impact garage doorsPGTCGI
Before
After
Before
After
Before
AfterViewLux Door Installation in Royal Palm Beach: What to Know First
We install ViewLux doors as an independent ViewLux service provider, typically completing a standard entry or swing door replacement in Royal Palm Beach in one visit, with most jobs taking between four and seven hours on site. ViewLux door installation in this area runs roughly $850 to $2,900 depending on the door line, hardware, and whether we’re doing a slab replacement or a full frame-out. We quote every job on paper before work starts and stand behind the install with our Done Right Promise.
This page is for Royal Palm Beach homeowners who own a ViewLux door and need it installed correctly or replaced because the old one binds, leaks, or simply won’t hold a seal anymore. If you’re reading this with a door that won’t latch square, call (386) 251-6745 and describe what it’s doing. One of our techs will tell you over the phone whether it sounds like a hinge adjustment or something deeper.
How ViewLux Products Fail - and How We Fix Them
- ViewLux 8500 Series entry doors losing alignment at the top hinge. We see this constantly in Royal Palm Beach homes built in the early 2000s. The top hinge plate pulls away from the jamb by an eighth of an inch or so, and the door starts catching the strike plate. The cause is usually the original install shims settling after twenty years of humidity cycles. We pull the casing, re-shim the jamb, and reset the hinge with longer screws into the stud. The door closes square again.
- French door astragals warping on south-facing exposures. The ViewLux double door astragal takes direct afternoon sun on the west and south sides of Royal Palm Beach, and over a decade it bows enough to let daylight through the center seam. Replacements from ViewLux can take three to five weeks. We keep a machined T-astragal in stock that fits the 8500 and the newer 9000 series profiles, so the door is weathertight the same week.
- ViewLux 7000 Series slider rollers flattening. These doors roll on two nylon rollers per panel, and after ten-plus years in Florida humidity the nylon deforms and the panel starts grinding on the track. If you’ve been living with a slider you have to shoulder into place, that’s the roller, not the track. We replace both rollers per panel, clean and re-lube the track, and the panel glides with two fingers.
- Threshold rot at the corners on older ViewLux swing doors. Royal Palm Beach gets sixty inches of rain a year, and the outermost corner of a ViewLux threshold is the first place water finds a path under the sill. The aluminum skin looks fine; the wood core underneath is gone. We pull the threshold, replace it with a composite-cap model that matches the ViewLux profile, and seal the corner with a polyurethane flashing tape before the new sill goes down.
- Pivot door hinge sag on oversized ViewLux custom doors. The 72-inch and wider pivot doors carry a lot of weight on a single point, and the pivot plate can drift a quarter inch out of plumb over time. That brings the latch edge down and makes the door bind against the floor. We re-set the pivot, re-torque the plate to spec, and check the door with a laser level across both diagonals before we call it done.
Our ViewLux Door Installation Process
- 1
The call. You tell us what the door is doing. We’ll ask whether it binds at the top or bottom, whether it leaks at the corners, and what year the house was built. That tells us which ViewLux generation you’re likely working with.
- 2
The measure. A uniformed, background-checked technician arrives and measures the opening twice. Rough opening width, height, diagonal corner-to-corner, and jamb depth. Every number goes on paper before anything is ordered or cut.
- 3
The parts decision. If the door itself is sound, we replace the failing component with OEM ViewLux parts where they’re available quickly, and quality aftermarket parts where they’re equal or better and in stock. We tell you which is which and why, on paper.
- 4
The install. We set the door, shim at the hinge points and the latch, and level both the slab and the jamb. Threshold, weatherstripping, and flashing are done to South Florida building code, not just to manufacturer minimums.
- 5
The test. We close the door, check the reveal line all the way around, run a dollar bill through the weatherstrip to confirm even compression, and spray the sill with water to confirm the seal holds.
- 6
The paperwork. Both manufacturer warranty layers get registered in writing, durations stated, before we leave the driveway. The Done Right Promise applies to our workmanship regardless of what the manufacturer covers.
What ViewLux Door Installation Costs in Royal Palm Beach
| Job Type | Typical Range |
|---|---|
| ViewLux slab replacement (standard entry door, no new frame) | $850 - $1,400 |
| Full frame-out install (new jamb, casing, threshold, entry or swing door) | $1,600 - $2,900 |
| French or double door install (two active or one fixed panel set) | $1,900 - $3,400 |
| Pivot door or custom oversized install | $2,800 - $4,500 |
| Slider or bifold door install | $1,400 - $2,600 |
What moves the price is whether the existing jamb can be saved, whether stucco or trim work needs patching after the old door comes out, and whether the door is a standard size or something custom. Doors with sidelites or transoms always run toward the higher end because the framing and flashing work doubles. We give you a written line-item quote before the job starts, and the number on that quote is the number on the final bill. Call (386) 251-6745 for a free estimate with exact figures for your door.
Why Royal Palm Beach Homeowners Call TruePane Windows & Doors for ViewLux Work
We’ve been setting doors and windows in Royal Palm Beach for over forty-two years, and Dale Kessler grew up off Crestwood Boulevard, so he knows exactly what the afternoon sun does to a west-facing entry door in July. Our technicians measure every opening twice, register both warranty layers in writing before leaving, and treat your home the way they’d treat their own mother’s. When a ViewLux door can’t be repaired economically, we also quote Andersen, Pella, PGT, and CGI side by side on paper so you can see the real difference in price and hardware before deciding. The Keystone Standard means you get both manufacturer warranty layers registered in writing with durations stated, and our Done Right Promise covers our workmanship with no paperwork fights. If the pane is not true, the job is not done.
FAQs
In most cases, yes, because ViewLux warranties cover the product itself when installed by a qualified contractor. We register both manufacturer warranty layers in writing on your behalf and state the durations in your paperwork. We can’t extend or expand a ViewLux warranty beyond what the manufacturer offers, and we won’t claim otherwise. Call (386) 251-6745 and we’ll look up your door’s serial number and tell you what’s covered before we schedule anything.
We match ViewLux hardware profiles and finishes as closely as the OEM and aftermarket parts allow. For older 7000 and 8500 series doors, exact factory finishes are sometimes discontinued, but we can usually source a matching or nearly identical finish from our parts distributors. We’ll show you samples before ordering so there are no surprises.
If the slab is structurally sound and the problem is the hinges, rollers, astragal, or threshold, repair usually makes sense and costs far less. If the door slab itself is warped, water-damaged, or delaminating, replacement is the honest answer, and we’ll quote both paths on paper so you can compare. We won’t sell you a new door when a $300 hinge and shim job fixes it.
Most standard entry and swing door installations in Royal Palm Beach are completed in a single visit of four to seven hours. French doors, pivot doors, and jobs requiring stucco or trim repair may run a second day. We’ll give you a straight answer on timing before the job starts, and we’ll be there when we say.
Yes, when the project requires one under Palm Beach County code, we pull the permit and schedule the inspection. We have been through Royal Palm Beach building inspection enough times to know what the inspectors look for, and our impact-adjacent work holds up to inspection the first time.
Written by Dale Kessler, Owner, TruePane Windows & Doors at TruePane Windows & Doors, serving Royal Palm Beach and nearby areas.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.