Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
Impact garage doorsPGTCGI
Before
After
Before
After
Before
AfterImpact Sliding Glass Door Cost in Royal Palm Beach, FL: What You’ll Actually Pay
A new impact sliding glass door in Royal Palm Beach runs $4,800 to $13,500 installed for most CBS ranch homes, with single-panel 6-foot sliders starting around $4,800 and multi-panel 12-foot to 16-foot openings reaching $11,000 to $13,500 or more when structural lintel work or HOA-mandated finish changes come into play. That’s the range we quote when we walk the opening, and the estimate holds because we measure twice and price once. Call (386) 251-6745 for a written quote on your exact opening, and you’ll know the number the same day.
Why Royal Palm Beach Homes Cost More Than the National Average
Royal Palm Beach’s planned subdivisions from the 1970s through the mid-1990s were almost entirely concrete block and stucco ranch homes. The original sliding glass doors in those houses were aluminum, single-pane, and sized to 6-foot, 8-foot, or 12-foot rough openings that don’t always match today’s standard impact-rated unit dimensions. When a homeowner asks us to price a replacement, we’re usually looking at custom sizing to fill the existing rough opening without cutting into the CBS block. That’s not a markup, it’s geometry.
Dale Kessler has been measuring these openings across Palm Beach County for the better part of three decades, and he’ll tell you the same thing he tells his crew: a tape measure doesn’t flatter anybody. Homes built before Hurricane Andrew in 1992 sat through Frances and Jeanne in 2004, and the sliding door that leaked air before the storm didn’t get better after it. Many of those original frames have settled or shifted a quarter inch out of square. An impact-rated unit has to sit dead level and dead plumb or the rollers bind, the interlock leaks, and the panel jams on the track within two summers.
Royal Palm Beach also sits inside Palm Beach County’s Wind-Borne Debris Region despite being 15 to 20 miles inland. Code requires impact-rated or wind-borne debris protected openings on any replacement door. That’s not optional in the village, and the building department checks. Then there’s the HOA layer: most Royal Palm Beach subdivisions have architectural review committees that must approve the door’s visible profile before the county permit gets pulled. That’s a second approval track many neighboring unincorporated communities don’t enforce as strictly. We handle both, so the door doesn’t get installed and then flagged.
What Drives the Cost on an Impact Slider
Every quote we write breaks down into a few fixed categories. These numbers reflect what we’ve actually installed in Royal Palm Beach, not national averages that don’t account for CBS openings, HOA reviews, or the Palm Beach County permit schedule.
| Cost Component | Typical Range in Royal Palm Beach |
|---|---|
| Impact-rated sliding door unit (6 ft, single panel, PGT or CGI) | $1,900 - $3,400 |
| Impact-rated sliding door unit (8 ft, two-panel, PGT or CWS) | $2,800 - $5,200 |
| Impact-rated sliding door unit (12 ft, three-panel, ViewLux or PGT) | $4,200 - $7,800 |
| Custom sizing (non-standard rough opening, pre-1985 CBS homes) | $600 - $2,200 |
| Frame modification or lintel reinforcement | $400 - $1,800 |
| Permit and HOA application fees | $150 - $650 |
| Labor, disposal, sealant, and flashing | $1,400 - $3,200 |
When we quote a door, the unit price is one line. The labor to remove the old aluminum slider without cracking the stucco is another. The sealant, the flashing, the anchor bolts rated for the wind load, the permit, the HOA packet, and the haul-away all show up as separate lines because that’s what an honest quote looks like. A low bid that lumps everything into one number usually doesn’t include one of those lines, and the homeowner finds out the day the crew shows up.
Common Local Scenarios We See
The 1978 CBS Ranch With the Original 6-Foot Slider
This is the bread and butter of Royal Palm Beach. The original aluminum frame has been caulked so many times the track is buried. The rough opening is 71 and three-quarter inches wide, but the closest standard impact unit is 72 inches. Not the end of the world, but the new frame needs a custom shoe or a slight pocket cut to sit right. We did this on a home off Crestwood Boulevard in March, and the job came in around $5,600 with a PGT single-panel slider. The homeowner had been told by another contractor that she needed a full wall rebuild. She didn’t. She needed someone who measures with patience.
The Florida Room Enclosure That Started as a Screen Porch
Royal Palm Beach’s older subdivisions have rear rooms that were screened porches in the 1970s and enclosed with aluminum jalousie windows sometime after. Those rooms often have sliding glass doors whose rough openings are 7-foot-4 or 9-foot-8 instead of a standard 6 or 8 feet. Impact-rated units in those widths are custom orders, and the wall framing behind the stucco is sometimes thin gauge. That adds $800 to $2,000 in framing modification before the door goes in. If a homeowner priced this job from a big-box flyer, the real quote surprises them. It shouldn’t. The surprise is what’s behind the drywall, not the number on the line item.
The HOA That Wants the Door to Match the Original Model Spec
Several Royal Palm Beach subdivisions keep strict architectural guidelines for rear-facing doors. The HOA may require a white aluminum frame, or a bronze finish that matches the original builder spec from 1988. That means special-order color selection, a longer lead time, and occasionally a higher unit price. We submit the HOA packet with the exact product cut sheet and finish code, and we don’t order the door until the committee signs off. It takes an extra visit, but it prevents a door installed and a violation letter in the mailbox.
- Pre-1994 homes: most likely to need custom sizing and lintel work.
- Post-2000 homes: standard openings more common, but seal failures and track wear are the usual reason for replacement.
- HOA communities: dual-track approval, budget two to four weeks for the review before the permit.
- West-facing rear sliders: afternoon heat and summer storms age weatherstripping faster, so the existing frame may be distorted.
We’re an authorized installer for PGT, CGI, CWS, among more than a dozen manufacturer lines. We quote them side by side on paper, with warranty durations stated in writing, so a homeowner sees what the price difference actually buys. Not all impact doors are equal, and a cheap unit installed square will outperform an expensive unit installed out of true. But the standard we care about is the install itself. If the pane is not true, the job is not done.
How the Installation Actually Works in Royal Palm Beach
When we install an impact slider, the first step is the HOA packet. We photograph the existing door, drop in the elevation drawing from the manufacturer, and note the finish and frame color. Once the committee signs, we pull the permit. Then we schedule the removal and install, usually the same day. The old slider comes out in one piece when we can manage it, because cracked stucco around the frame is an avoidable repair on most CBS openings. The new frame is anchored to the block, shimmed to dead plumb, and sealed with a continuous bead of sealant rated for our climate. Rollers adjusted, interlock checked, panel set. Then the warranty registration: both manufacturer warranty layers, in writing, before the truck leaves the driveway. That’s the Keystone Standard, and it’s been the rule at TruePane since Dale Kessler founded the company in 2008.
Most jobs are completed in a single visit. A live person answers the phone 24 hours a day, seven days a week, because a sliding door that won’t close in the middle of a summer storm is not a problem that waits for a callback form. Our technicians are background-checked and uniformed, and they work in a customer’s home the way they’d work in their own mother’s. Dale’s father spent twenty years in general contracting and taught him early that a bad window installation costs twice what a good one does. We price accordingly, which is to say: you’ll pay a fair number, the work will be true, and the warranties will be in writing.
Frequently Asked Questions
A standard 6-foot impact sliding glass door in Royal Palm Beach costs $4,800 to $6,500 installed, while larger multi-panel doors run $8,000 to $13,500 depending on width, frame finish, and whether custom sizing is required. Our quotes always include permit, HOA submission, removal, haul-away, and both manufacturer warranty registrations in writing. Call (386) 251-6745 for an exact number on your opening.
In Royal Palm Beach, a track repair or roller replacement runs $250 to $800, while a full impact-rated replacement starts around $4,800 installed. If your current door is original to a pre-1994 home, it likely does not meet Palm Beach County’s wind-borne debris requirement, and repairs won’t fix that compliance gap. We’ll give you an honest recommendation without steering you toward a door you don’t need.
Yes, the Village of Royal Palm Beach requires a building permit for any door replacement, and most subdivisions also require HOA architectural review before the permit is issued. We prepare and submit both applications, and we don’t order the door until the approvals are in hand.
For a standard 6-foot or 8-foot opening with a common finish, we can often install the door the same day we remove the old one, once the permit and HOA approvals clear. Custom sizes and special-order finishes typically take two to four weeks from order to install. Call (386) 251-6745 and we’ll check current stock and give you a straight answer.
Get a Straight Number on Your Sliding Door
You’ve been through enough quotes that don’t hold up. Ours are written line by line, with both manufacturer warranty layers registered before we leave the driveway, and a Done Right Promise with no paperwork fights. Call TruePane Windows & Doors at (386) 251-6745 today, and we’ll measure your opening, price the options on paper, and do the work right the first time. Ask about our senior and veterans discount when you call.
Written by Dale Kessler, Owner, TruePane Windows & Doors at TruePane Windows & Doors, serving Royal Palm Beach, FL.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.
Other TruePane Windows & Doors Services
What Neighbors Say About TruePane Windows & Doors
What Our Customers Say
"A casement crank had stripped and the sash was swollen shut. The technician, Ray, fixed the crank on the spot and only then talked about replacement for the three windows that were genuinely done. That is why the whole street uses them now."
- Eleanor G."Eleven windows replaced in two days. The crew chief, Marcus, showed me the level on every single frame before they caulked it. My wife noticed the street noise was gone before I did."
- Ronald P."Quote was the price, which after three other bids that grew legs was worth something. Double-hungs went in clean, they hauled the old ones, and the registration paperwork for the warranty came in the mail like they said."
- Dorothy K.