Sliding Glass & Patio Doors in Royal Palm Beach - Free In-Home Measure, Written Price

Trusted Sliding Glass & Patio Doors for Royal Palm Beach Homeowners

Sliding glass and patio doors in Royal Palm Beach take a beating from the Florida sun, monsoon season downpours, and the salt air that drifts in from the coast. When the track gets gritty, the rollers wear out, or the frame starts to bind, most homeowners have a door that fights them every morning and leaks every August. TruePane Windows & Doors has been setting out-of-true panels straight since 2008, and Dale Kessler still holds every install to the founding rule: if the pane is not true, the job is not done. We replace, repair, and tune sliding doors in Royal Palm Beach, and our techs arrive in uniform, with manufacturer parts on the truck, ready to measure twice and price on paper before any work begins. Call (386) 251-6745 for a free estimate on a sliding glass door that rolls like it should.

Call (386) 251-6745

What Our Sliding Glass & Patio Doors Service Includes

Slider Repair and Roller Replacement

Sliding door rollers are the first thing to go in Royal Palm Beach. The fine sand from backyard pavers and the humidity that swells wooden frames grind down the nylon wheels inside the track until the door scrapes instead of slides. When the panel gets heavy or starts to jump on a bump, we lift the door out of its track, replace worn rollers with manufacturer-matched parts, and clean and realign the bottom channel so the panel carries its weight evenly. A repaired door should move with two fingers, not a shoulder.

Sliding Door Frame and Track Alignment

Concrete slabs in South Florida settle, and when they do, sliding door frames rack out of square. You will notice the door drags on one end of the track, leaves a gap at the strike side, or will not latch without a hard pull. TruePane technicians set the frame back to plumb and level, shim and secure it against the rough opening, and adjust the wheels so the panel sits true in the channel. This is the difference between a door that holds a hurricane brace and one that rattles in the wind.

Patio Door Glass Replacement

Fogged glass, a cracked lite, or a failed seal on a patio door is a glass replacement job, not a whole-door replacement. We cut and install insulated glass units matched to the existing frame, whether it is a standard slider or a two-panel unit with low-E coating for western exposure. In Royal Palm Beach, most homeowners see the biggest comfort gain from sealing failed dual-pane units that have been letting moisture build up between the lites for years.

Fogged and Failed Seal Repair

When the desiccant in a sealed unit gives out, condensation forms between the panes, and no wiping from inside or out will clear it. That failed seal is what we mean when we say a pane is not true: the insulating gas is gone, and so is the door’s ability to block heat transfer. TruePane replaces failed sealed units under a clear, written warranty registration, and The Keystone Standard means both the glass manufacturer warranty and the workmanship warranty get registered in writing before we leave the driveway.

Sliding Door Hardware Upgrade and Latch Repair

A sliding door that will not lock is not a sliding door; it is an open invitation. Latches misalign as frames settle, and handle sets wear out from twelve thousand cycles a year. We install new multipoint locksets, upgrade builder-grade handles to heavy-duty hardware, and align the striker so the latch throws clean every time. The homeowner gets a door that bolts true and unlocks from the outside, and the house gets one less openable entry point.

Brands We Service for Sliding Glass & Patio Doors

TruePane carries OEM rollers, latches, and replacement glass for PGT and CGI sliding doors, the two lines we see most often in Royal Palm Beach because both build for Florida’s wind-load requirements. We have pulled PGT 5500 and 2500 series doors out of tracks that were never set square from the day the builder left, and we have re-glazed CGI two-panel sliders where the original seals gave out after ten years of western sun. When we quote a PGT or CGI repair, we quote using the manufacturer’s own part numbers, and we register both warranty layers through the manufacturer’s paperwork, not our own.

We also service and install ViewLux patio doors for homeowners who want a slimmer frame profile and more glass. ViewLux units sit heavier in the track than vinyl, so the roller load rating and track prep matter more. A TruePane tech who sets a ViewLux panel will level the existing threshold before they swap a single bearing. Whether your door is PGT, CGI, Therma-Tru, or a builder-grade line that has faded from the label, we can measure, source, and set it right. If we cannot get the part, we will say so up front, in writing, with the price of the alternative on paper beside it.

Signs You Need Sliding Glass & Patio Doors Right Now

• The door sounds like it is dragging gravel. That grinding noise is a roller that has lost its bearing or a track packed with sand and debris. Left alone, the door starts sawing into the aluminum track, and a $45 roller job becomes a track replacement.
• Condensation sits between the two panes. A fogged lite means the seal has failed and the insulating gas has leaked out. Your energy bill is climbing even while the glass looks clean from the outside. The fix is a sealed-unit replacement, not a new door.
• The door binds in the summer and frees up in the winter. When the aluminum frame heats up in direct sun, it expands. If the frame was racked out of square at install, the panel pinches against the jamb every afternoon. In Royal Palm Beach, the bind shows up first on western-facing sliders by mid-June.
• You can see daylight around the closed panel. Gaps at the interlock or the strike side mean air, rain, and bugs are moving through the opening. A door that does not seal is a door that is not doing its job, and no weatherstripping job will fix an out-of-square panel; the frame has to be corrected.
• The lock takes two hands and a knee to throw. Latches misalign when the panel sags or the house settles. Forcing the fixture only bends the keeper further. TruePane repairs the alignment and tests the lock at 70 pounds of pull, because a sliding door that does not lock is the weakest entry point on the house.

Our Sliding Glass & Patio Doors Process - Step by Step

1. On-site measurement, not a phone quote. The technician arrives at the scheduled time, in uniform, and measures the rough opening, the panel weight, the track wear pattern, and the reveal on both jambs. We take the door’s dimensions twice because an eighth of an inch out of square is the difference between a panel that rolls straight and one that rides the rail for twenty years.

2. Side-by-side written quote. You get a line-item quote on paper, with the manufacturer part numbers and the labor listed separately. If we are quoting a replacement door, we show you the options from the manufacturer lines we service, typically side by side with their actual warranty durations, so you can compare what you are buying. We do not give a vague number and settle up later.

3. Parts staged and job scheduled. If the job needs a specific roller, sealed unit, or lock set, we order it, verify it against the measurement, and bring it on the first trip. Our most common slider repairs are completed in a single visit because the truck is stocked with the hardware Royal Palm Beach doors actually need, not just generic boxes.

4. Repair or replacement, done to the Keystone Standard. The panel comes out, the track gets cleaned and leveled, the frame is checked for square, and the new parts go in. Every adjustment is checked with a four-foot level and a pull test. Before we reinstall the panel, we confirm the plumb line is true, because the standard is not “good enough,” it is “pane true.”

5. Warranty registered, then we walk the door with you. Both warranty layers get registered in writing before our tech leaves your driveway. Then we stand at the door with you, open and close it three times, show you the lock throw and the seal, and wait for your questions. We leave the area cleaner than we found it and give you the paperwork in a folder, not an email you will never open.

How Much Does Sliding Glass & Patio Doors Cost in Royal Palm Beach?

Sliding Glass & Patio Doors Near Royal Palm Beach - Our Service Area

TruePane runs sliding door service calls across the western communities and the coastal corridor. We work in Westlake and Loxahatchee Groves as often as we work within Royal Palm Beach village limits, and our techs know the slab-soil patterns that make western-corridor doors settle differently from ones in Westgate or Wellington. We also take appointments in West Palm Beach, Greenacres, Atlantis, Palm Beach Gardens, Riviera Beach, and Lake Park. Most Royal Palm Beach repair calls happen within a two-day window, and the truck is stocked for the doors most common in this stretch of the county.

Frequently Asked Questions - Sliding Glass & Patio Doors in Royal Palm Beach

Schedule Your Sliding Glass & Patio Doors Service in Royal Palm Beach Today

Call (386) 251-6745 and tell us what your sliding door is doing, and a live person will schedule your free estimate. We’ll measure, diagnose, and put the price on paper, and the job gets done to the standard Dale Kessler has kept on the whiteboard since 2008. If the pane is not true, the job is not done.

Written by Dale Kessler, Owner at TruePane Windows & Doors, serving Royal Palm Beach since 2008.